Any (OrcaSlicer 2.5) / Fuzzy Skin — PLA start

Fuzzy Skin — PLA start on Any (OrcaSlicer 2.5)

guide

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Any (OrcaSlicer 2.5)

Filament brand

PLA

Filament type

Fuzzy Skin — PLA start

Slicer

OrcaSlicer 2.5

Nozzle size

0.4 mm

Nozzle temp

190-220 °C

Bed temp

50-60 °C

Notes

PLA tolerates higher fuzzy deviation but can snap if deviation is too sharp (guide). Start ~0.2 mm; Contour mode; Displacement/Combined generators preferred in 2.5.

Source: 3D Printing Basics · 2026-09-06

Summarized from the linked source. Always test on scrap before production runs.