Silk PLA on Sovol SV08

youtube

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Sovol SV08

Filament brand

—

Filament type

Silk PLA

Slicer

OrcaSlicer

Nozzle size

0.4 mm

Nozzle temp

210 °C (first layer 215 °C)

Bed temp

60 °C

Notes

Minimal 3DP OrcaSlicer temp-tower video on a Sovol SV08 (Micro Swiss FlowTech hotend): Silk PLA tower run 190–230°C in 5°C steps; author previously printed at 220°C and chose 210°C after inspecting stringing and surface quality, with first layer 215°C and bed raised to 60°C. Flow ratio set to 1 and pressure advance enabled before later calibration tests.

Source: Minimal 3DP

Summarized from the linked source. Always test on scrap before production runs.