PETG Translucent on Snapmaker U1

official

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Snapmaker U1

Filament brand

Snapmaker

Filament type

PETG Translucent

Slicer

Snapmaker Orca

Nozzle size

0.4 mm

Nozzle temp

240–260 °C

Bed temp

60–85 °C

Speed

50–150 mm/s

Layer height

lower layer height for clarity

Cooling

0–60% (off or low for best translucency and layer bonding)

Notes

Snapmaker: dry 65 °C for 6 h if not used straight from the bag. For max translucency set all speeds equal and slow, nozzle slightly hotter, flow ratio slightly up, fans off; spiral vase for lampshades, 100% infill for solid parts. Delamination means raise nozzle 5–10 °C or cut the fan.

Source: Snapmaker

Summarized from the linked source. Always test on scrap before production runs.