PETG on Anycubic Kobra 3 Max

community

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Anycubic Kobra 3 Max

Filament brand

Kingroon

Filament type

PETG

Slicer

Anycubic Slicer Next

Nozzle size

0.4 mm

Nozzle temp

245 °C first layer, then 260 °C

Bed temp

80 °C (PEI)

Layer height

first layer 0.28–0.3 mm

Notes

drucktipps3d forum: a new K3M owner had stringing and poor adhesion at 235 °C / 75 °C bed; replies said that is too cool. With 245 °C first layer / 80 °C bed (260 °C later) the 17 h print ran clean. Dry PETG a few hours at 65 °C; wash the bed with dish soap after PLA.

Source: drucktipps3d forum · 2026-05-26

Summarized from the linked source. Always test on scrap before production runs.