PETG-HS on Anycubic Kobra 3 Max

community

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Anycubic Kobra 3 Max

Filament brand

eSUN

Filament type

PETG-HS

Slicer

Anycubic Slicer Next

Nozzle size

0.4 mm

Speed

first layer 10–15 mm/s

Notes

3D Printing Forums: messy, non-sticking first 10 layers of eSun PETG-HS on a Kobra 3 Max came from too much squish. Raise Z-offset about 0.05 mm and slow the first layer to 10–15 mm/s.

Source: 3D Printing Forums · 2025-09-22

Summarized from the linked source. Always test on scrap before production runs.