PETG on Anycubic Kobra S1 (enclosed)

youtube

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Anycubic Kobra S1 (enclosed)

Filament brand

Generic

Filament type

PETG

Slicer

Anycubic Slicer Next

Nozzle size

0.4 mm

Nozzle temp

240 °C (250 °C strung badly in the enclosed printer; 250 °C works on open bed slingers)

Chamber / enclosure

Enclosed

Retraction

1.0 mm (up from 0.8 mm, reduced stringing)

Notes

donmarkon video (Aurora Whisper transcript): with temp and retraction fixed, the remaining stringing came from wet filament, and drying it (about 12 h total) gave a clean print. Overhang creep went away at 240 °C.

Source: donmarkon

Summarized from the linked source. Always test on scrap before production runs.