PLA on Any (brand filament profile)

official

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Any (brand filament profile)

Filament brand

Hatchbox

Filament type

PLA

Slicer

OrcaSlicer / Cura / PrusaSlicer

Nozzle size

1.75 mm filament

Nozzle temp

180–210 °C

Bed temp

0–60 °C

Speed

start 40 mm/s

Cooling

100% after first layers

Notes

Official Hatchbox PLA material page: recommended extrusion 180–210°C, build platform 0–60°C, blue painter’s tape for adhesion. Printing tip: start at 180°C nozzle and 40 mm/s, then adjust; run part-cooling fan at 100% except the first few layers.

Source: HATCHBOX

Summarized from the linked source. Always test on scrap before production runs.