Fiberon PETG-rCF08 on Any (brand filament profile)

official

Test on scrap first. Settings are starting points from the linked source. Dry hygroscopic filaments before printing.

Printer

Any (brand filament profile)

Filament brand

Polymaker

Filament type

Fiberon PETG-rCF08

Slicer

OrcaSlicer / Bambu Studio / PrusaSlicer

Nozzle size

0.4 mm hardened nozzle required

Nozzle temp

240–270 °C

Bed temp

60–70 °C

Chamber / enclosure

Room temperature (keep door open on enclosed printers)

Speed

30–300 mm/s

Cooling

Fan 0% (max 50%; reduce if layer adhesion suffers)

Notes

Polymaker wiki printing recommendations. All-metal hotend recommended but not needed. Don't run it through an AMS (abrasive).

Source: Polymaker

Summarized from the linked source. Always test on scrap before production runs.